1500w 240v R7s Replacement Infrared Lamp Halogen Infrared Lamp Heater for Pet Blowing Machine on IR UV Industry

quartz halogen heat lamp pet blowing machine

Mon, 29 Jun 2026 01:21:12 +0800

Getting to the Heart of the Power Profile

We build these quartz halogen heat lamps with one job in mind: to handle the tough demands of a PET blowing machine. They’re built around a 400V, 2500W power profile, because that’s what it takes to deliver the kind of heat density needed to soften those PET preforms—fast and without fail. The 300mm tube length is a deliberate choice, too. It matches the heating zone of standard blow molding heads, so the heat lands exactly where it needs to, right on the preform, without going off-target. Here’s the thing about that high-wattage, high-voltage setup: it actually pulls less current for the same heat output. And less current means you can use smaller wiring, you get less voltage drop, and the temperature at the lamp face stays rock-solid. The trade-off? You do need a machine that’s set up to handle the heat and the 400V supply. But when it’s done right, you get heat that’s both rapid and easy to control.

screen printing halogen

Sun, 03 May 2026 21:56:44 +0800

Introduction

Let’s get real about screen printing: if your ink isn’t drying fast, your whole line is stuck waiting. That’s why we built these halogen heaters to be small but seriously powerful. They pack a concentrated punch of heat, curing prints on flat or curved surfaces without needing a ton of room. The whole point is simple: help you run faster, and still keep every print looking sharp.

The Specs That Actually Matter

Here’s the thing—these heaters are designed to run on a standard 400V supply, and you’ll often see them rated at 2500W. That power level hits a sweet spot: it delivers enough radiant heat to cure ink quickly, without making the heater itself bulky. The tube length is usually around 300mm, and that’s intentional. It keeps the heat focused right where you need it—on the print. That means more consistent temperature across the surface, and less wasted energy heating air instead of ink. Running high voltage at the heater terminals also helps. For the same power, you get lower current. Lower current means you can use smaller wiring, smaller contactors, and you won’t lose power to voltage drop over longer runs. On a press where the heater might sit a meter or more from the control cabinet, that detail actually matters.

39.25 240v 2000w halogen heat lamp

Wed, 29 Apr 2026 20:10:49 +0800

Introduction

We built this 39.25-inch, 240V, 2000W halogen heat lamp for one reason: to give industrial setups serious heat—in a tight space. If you’re an engineer, you know the feeling. You need something that just works, behaves predictably, and doesn’t force you to redesign the whole machine just to make it fit. This lamp was made for that.

Power, Voltage, and Size—Plain and Simple

At 2000W and 240V, this thing delivers steady, predictable resistive heating. No guesswork. You know exactly what you’re pulling, so you can size your power supply and controls without stress. And the length? 39.25 inches (about 1000mm). That gives you enough spread to manage temperature across a specific zone, without being so long it becomes a headache to install. It hits that sweet spot: long enough for the job, short enough to squeeze into tight enclosures.